DENALI Premium Powersports Wiring Harness Kit for DENALI Lights

The DENALI Premium Powersports Wiring Harness is the same as that included with the DENALI lights kits D2, D4, D7, DM, DR1 (but not the S4).

All connectors are waterproof and use high quality molded heat-shrink to prevent water ingress to the cables.
The ON/OFF switch is also sealed/waterproof and may be mounted directly onto a flat surface or onto bars 22mm/1"with the included brackets.

The harness connects directly to the battery and provides two powered outputs controlled by the ON/OFF switch with an overriding trigger-wire so the lights cannot be switched on when the engine is not running.

The harness supports the use of the optional accessory DataDim™ controller to allow the intensity of the lights to be synchronized (50%/100%) with the low/high beam lights.

Kit Contents

1. Premium harness (with 10A fuse preinstalled) x 1
2. Single intensity relay (pre-installed in the harness) x 1
3. Waterproof ON/OFF switch x 1
4. Switch adhesive pad for surface mounting x 1
5. Switch bracket for 22mm (7/8") bars x 1
6. Switch bracket for 25.4mm (1") bars x 1
7. Self-tapping screws x 2
8. Cable ties x 4
9. 20A fuse for use with D7 x 2 lights

Installation

The DENALI D7 uses the same componentes, download the installation manual here.