Payment and Shipping Options
|
Licence Plate Holders - spares
Displaying 1 to 10 (of 17 Products)
Product Name
Manufacturer
Model
Price
|
R&G Racing Indicator Protector/Heat Shield. This product is compatible with these bikes: KTM 790 Duke - 2018 KTM 790 Duke - 2019 KTM 790 Duke - 2020 KTM 790 Duke - 2021 KTM 790 Duke - 2022 KTM 790 Duke - 2023 KTM 790 Duke - 2024 KTM 790...
|
Fitting your existing licence plate to a R&G Tail Tidy often requires re-drilling or even purchasing a new one. These Licence Plate Adapters/Extensions greatly increase the range of the possible fitting points to allow the existing number plate to be re-used without re-drilling (in the majority of cases). Two adapters are included in this kit. NO TAIL TIDY...
|
Panel Set for LP0008BK (for use with the Honda CBR1000RR 2006-2007). How to find R&G products for your bike? Given the huge range of products it is really not practical to just browse/look for the product(s) that may be compatible for your bike and so we strongly recommend you FIRST find the R&G product model number by one of the following methods. Use...
|
Replacement shroud for the LA0002 LED numberplate light as normally used in R&G Racing "Tail Tidy" license plate holders. How to find R&G products for your bike? Given the huge range of products it is really not practical to just browse/look for the product(s) that may be compatible for your bike and so we strongly recommend you FIRST find the R&G...
|
Fitting lower-current aftermarket indicators can result in the flashing rate being too fast or slow depending on the electrical system of the motorcycle. To cure this, a load resistor can be fitted in the circuit of each indicator to increase the current load on the flasher relay This pack includes two resistors for use with lower wattage filament bulbs than...
|
Fitting LED aftermarket indicators can result in the flashing rate being too fast or slow depending on the electrical system of the motorcycle. To cure this, an RG Loading Resistor can be fitted in the circuit of each indicator. This pack includes two resistors for use with LED indicators. PLEASE NOTE: This is a generic product which is displayed by default...
|
Fitting LED aftermarket indicators can result in the flashing rate being too fast or slow depending on the electrical system of the motorcycle. To cure this, an RG Loading Resistor can be fitted in the circuit of each indicator. This pack includes two resistors for use with LED indicators. Recommended for 790 Duke with micro indicators. PLEASE NOTE: This is a...
|
LED Rear Light for race and track use. Ensure that you can be seen by your competitors even in the worst conditions. The R&G Racing Rain Light is bright, compact and easy to install. The kit includes everything necessary for a complete installation including a low-profile housing and a switch to clip onto the handlebar. Kit Contents Rain Light (six leds)...
|
Replacement bolt-on rectangular reflector. As used in the REK0001 and REK0002 kits. How to find R&G products for your bike? Given the huge range of products it is really not practical to just browse/look for the product(s) that may be compatible for your bike and so we strongly recommend you FIRST find the R&G product model number by one of the...
|
Replacement bolt-on round reflector. As normally included with the licence plate holders "Tail Tidys". ONE reflector only. How to find R&G products for your bike? Given the huge range of products it is really not practical to just browse/look for the product(s) that may be compatible for your bike and so we strongly recommend you FIRST find the R&G...
|
Displaying 1 to 10 (of 17 Products)
|