This pattern is specifically designed for the Honda CBR1000RR 2008-2011.
Eazi-Guard™ is a transparent protective film, designed to protect any surface from damage due to stones, gravel, salt, tar and anything else that real-world use can throw at your bike.
What is it made from?
Eazi-Guard™ is an ultra-thin, ultra-tough polyurethane film with additives to ensure it does not yellow over time in the sun. It will not crack nor shrink – Guaranteed!
Who uses it?
Eazi-Guard™ is currently protecting many of the leading race teams in BSB, WSB and Road Racing including HRC, Milwaukee BMW, JG Speedfit Kawasaki, MV Augusta Racing, Tsingtao Racing and Quattro Plant Kawasaki.
Eazi-Guard is sponsoring the Yamaha Europe R3 and R125 cup, with all bikes featuring Eazi-Guard™ protection. It is also extensively used at the NW200 and Isle of Man TT races.
Sponsored Teams: Road Racing | Short Circuit
Eazi-Guard™ Pre-cut Bike-Specific Kits
The pre-cut kits are created using a precision laser-based measuring system. It will protect the most vulnerable parts of the bike from stone damage, as detailed in the product’s images and description.
The kits are easy to fit by the home-user and usually include protection for the front of the front mudguard, nose cone, leading edges of the fairings and the tail unit.
List of kits available Eazi-Guard pricelist.
Eazi-Guard™ Universal Kits
Universal kits are available in two sizes.
Standard: 50cm x 71cm
Large: 48cm x 139cm
Rolls are also available in 75mm, 100mm and 150mm widths to protect forks, grab rails and swingarms, contact us for details.
How to install Eazi-Guard™?
The pieces in the pre-cut kits are designed to be easily-manipulated and installed by the home-user.
The material has a high elasticity to allow it to be easily stretched over bodywork curves. The film uses a special adhesive that although strong, can be removed leaving NO residue whatsoever.
- Clean the surface.
- Moisten the surface with the supplied solution.
- Remove the Eazi-Guard™ backing layer.
- Place the Eazi-Guard™ piece on the wet surface.
- Slide the piece to its correct position.
- Moisten the exterior surface of the Eazi-Guard™.
- Squeeze out the moisture from under the film to allow the adhesive to touch the surface.
- Stretch the piece as required to cover any curves in the surface.
The adhesive bonding time can be reduced using a hair dryer, to enable quick adhesion to tight curves.
Installation Video - Nose Cone
Installation Video - Mudguard
All products supplied by Motorvista include instructions in english and spanish.
For more information, please visit this product's website.
There are currently no product reviews.