DENALI T3 Switchback Indicators - Front

The DENALI T3 Switchback Indicators (2) offer three functions in the front-facing version:

• Indicator – amber – HIGH intensity
• Daytime/visibility light – white – LOW intensity
• Daytime/visibility light – white – HIGH intensity

These front indicators are intended to replace the original indicators.
The lights are extremely bright and have a 180º viewing angle.

The T3 have E-Mark approval, you may download the certificate from here.

Note that in general, when replacing OEM indicators that use filament bulbs with LED indicators, it is common that the LED indicators flash too quickly because the current drawn is too low.
In this case it is necessary to install a load resistor in parallel with each indicator to draw the necessary current for the flashing relay to function correctly.

To replace a 7/10W load, use load resistors: RGR0001.
To replace a 21W load, use load resistors: RGR0002.

Features

• Six high-power LEDs per module
• Low profile design
• Current consumption: DRL white 50% 0.04A / DRL white 100% 0.11A / Indicator amber 0.52A
• Size: 63 x 28 x 17mm
• Weight: 36g

DENALI T3 Range

• DNL.T3.10000 - Front Indicator replacement (8mm) / Daytime light 50% / Daytime light 100%
• DNL.T3.10100 - Rear Indicator replacement (8mm) / Rear light / Brake light
• DNL.T3.10200 - Additional Front Indicator / Daytime light 50% / Daytime light 100%
• DNL.T3.10300 - Additional Rear Indicator / Rear light / Brake light

Kit Contents

1. DENALI T3 Front Indicator Modules x 2
2. M8 nuts x 2
3. Posi-lock connectors (for indicator wiring) x 4
4. Posi-tap connectors (for white light control) x 4
5. Installation instructions

Installation

The lights are designed to be fitted into 8mm holes. If adapters are required, we have a large range from R&G Racing here.

The white lights may be wired to the low beam (50%) circuit and the high beam (100%) circuit or connected directly to a key-switched supply. See the instructions for more details.