PowerHub3 - 12 V Power Distribution Hub

The INNOVV Power Hub 3 allows you to supply 12 V power for up to five accessories.

The module is connected directly to the battery and supplies +12 V power to the accessories 10 seconds after the ignition is operated and for 10 seconds after the ignition is switched off.

Features

• Output current: up to 5 A per output (15 A total maximum).
• On delay: the outputs are activated 10 seconds after the ignition is switched on/yellow wire is powered.
• Off delay: the outputs are deactivated 10 seconds after the ignition is switched off/yellow wire is powered down.
• Safety: each output is individually fused (3 A) for extra protection. The 3A fuse can be changed for a 5 A if necessary.
• Low standby current: the module consumes less than 10 µA when not in use so will not drain the battery even when not used for weeks.
• Waterproof: the module is rated at IP67/completely waterproof.
• Innovv Product Description (pdf)

Connections

1. Red wire input (14 AWG, 80 cm, 15 A fuse): +12 V battery connection
2. Yellow wire input (22 AWG, 80 cm): control/trigger wire from any key-switched 12 V source such as the rear light.
3. Black wire input (14 AWG, 80 cm): 0 V battery connection
4. Black wire output (18 AWG, 60 cm): common 0 V /ground connection for all accessories.
5. Red wire output 1 (18 AWG, 60 cm, 3 A fuse): key-switched +12V output.
6. Red wire output 2 (18 AWG, 60 cm, 3 A fuse): key-switched +12 V output.
7. Red wire output 3 (18 AWG, 60 cm, 3 A fuse): key-switched +12 V output.
8. Red wire output 4 (18 AWG, 60 cm, 3 A fuse): key-switched +12 V output.
9. Red wire output 5 (18 AWG, 60 cm, 3 A fuse): key-switched +12 V output.