DENALI Standard Wiring Harness Kit for Driving Lights

The DENALI Standard Powersports Wiring Harness is the same as that included with the DENALI S4 light kit.

All connectors are waterproof and use high quality molded heat-shrink to prevent water ingress to the cables.
The ON/OFF switch is also sealed/waterproof and is intended to be surface mounted.

The harness connects directly to the battery and provides two powered outputs controlled by the ON/OFF switch with an overriding trigger-wire so the lights cannot be switched on when the engine is not running.

The harness supports the use of the optional accessory DataDim™ controller to allow the intensity of the lights to be synchronized (50%/100%) with the low/high beam lights.

Kit Contents

1. Standard harness x 1
2. Single intensity relay (pre-installed in the harness) x 1
3. Waterproof ON/OFF switch x 1
4. Switch adhesive pad for surface mounting x 1
5. Cable ties x 4

Installation

Download the installation manual here.