SpeedoHealer SH-D01 "Plug n' Go" Harness (Ducati, MV Agusta...)

SpeedoHealer Harness SH-D01.

SpeedoHealer Cable Harness

A compatible SpeedoHealer harness is always required to allow the vehicle's speed signal to pass through the SpeedoHealer module for correction.

For most bikes a "Plug n' Go" harness is available which has the same original-style connectors as the vehicle and so a SpeedoHealer module can be connected to the speed sensor without any cutting or jointing of the original wiring or requiring additional power connections. In almost all cases, the SpeedoHealer module can use the power and ground connection supplied by the ECU.

However, this is not always possible if the vehicle has an uncommon style of connector or the cable carrying the speed signal is part of the main ECU wiring harness (as for bikes with ABS), and so the correct wire must be cut and a universal harness be used to bridge the signal through the SpeedoHealer module. High-quality 3M jointing connectors are provided with the universal harnesses.