Quickshifter easy harness - QSR-F2F-L (includes shift rod 15-18cm)

Quickshifter easy QSR-F2F-L harness for use with the Healtech iQSE-W1 module.

This harness includes a long replacement shift-rod (15-18cm / 6mm diameter) to allow the installation of the QSS ring sensor (M6) with some aftermarket rearsets used with the KTM Super Duke R.
If your rearsets already use a 6mm diameter shift rod, you may use the QSH-F2L cable instead.

Please use the Healtech Product Advisor below to check this cable is compatible with your bike.

Please take great care in selecting the correct harness especially if you have an Aprilia/Suzuki which may require the QSX-P4B and not the QSH-P4B.

Notes

In general the harness recommended by the Advisor is simply the easiest one to install.
"QSH-Fxx": connect to the injectors.
"QSH-Pxx": connect to the coils.
"QSH-P2T/QSH-P4T": requires the coil power cable to be cut and bridged by this harness. The kit includes all necessary parts and instructions.
"QSX": include additional electronics in the harness itself. Some bikes detect the ignition cut and show a "FI" error. The additional electronics prevent this problem.
"QSR": include a replacement shift-rod (M6) where it has been found necessary for the installation of the ring sensor.