Reflector Extender Kit (2 position)

Reflector bracket for horizontal (2 position) R&G Tail Tidies.

This kit allows the easy installation of a rectangular reflector onto an R&G Racing licence plate holder.

The support bracket screws into the holder and the reflector is pushed up against the lower edge of the number plate and then tightened.

Supplied with a large (30mm x 85mm) E-Marked reflector.

There are two styles of kit available depending on the model of tail tidy you have:
for the triangular-type holder with three fixings, use the RG-REK0001BK
for the horizontal-type holder with two fixings, use the RG-REK0002BK.

How to find R&G products for your bike?

Given the huge range of products it is really not practical to just browse/look for the product(s) that may be compatible for your bike and so we strongly recommend you FIRST find the R&G product model number by one of the following methods.

• Use this up-to-the minute R&G compatibility document (pdf) to find the products compatible with your bike
• Or, look in the R&G Racing website to find the products compatible with your bike.
• Or, use the above drop-down menu "Show Products for..." to find all our compatible products for your bike, including those from R&G Racing (due to constant and rapid product development by R&G, this section may not include all the currently available products).

Once you know the R&G product model number e.g. LP0108BK, just start typing the model into the search field at the top of this page and the product should be listed in the popup results.

If you cannot find a product, please don't hesitate to Contact Us as it may be a new product we have not yet included in our shop.